Apollo Seiko OMEGA - Page 12

12 / 60
11.3.17 N : Easy Slide Soldering Completion Report
【Code】 ４ＥＨ(‘Ｎ’)
【Function】
Easy slide soldering completion report
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
Refer to “13.6 Special Soldering Easy Slide Soldering Operation” about operation.
1
2
3
4
5
STX
‘Ｎ’
ETX SUM
11.3.18 K : Temperature Controller SV Change
【Code】 ４ＢＨ(‘Ｋ’)
【Function】
Temperature controller SV change
【Direction】
External controller → Soldering controller
【Data】
Temperature 3 digits (hexadecimal notation)
【Explanation】
A specified temperature is set to “Setting temperature” of system parameter.
W
hen
it is a
value
above
the maximum temperature setting, it will not set.
1
2
3
4
5
6
7
8
STX
‘Ｋ’
Set temperature ETX SUM
11.3.19 P : Manual Solder Feeding Start
【Code】 ５０Ｈ(‘Ｐ’)
【Function】
Manual solder feeding start
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
When it receives this command while automatic operation is stopping, it starts to
feed the solder wire.
It continues to feed the solder until it receives Manual solder feeding end
command.
1
2
3
4
5
STX
‘Ｐ’
ETX SUM
11.3.20 Q : Manual Solder Feeding End
【Code】 ５１Ｈ(‘Ｑ’)
【Function】
Manual solder feeding end
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
If it receives this command during manual solder feeding, it stops manual solder
feeding.
I
f it receives this command during
Manual sold
er revering, it ignores the command.
1
2
3
4
5
STX
‘Ｑ’
ETX SUM