Apollo Seiko OMEGA - Page 13

13 / 60
11.3.21 R : Manual Solder Reversing Start
【Code】 ５２Ｈ(‘Ｒ’)
【Function】
Manual solder reversing start
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
If it receives this command while automatic operation is stopping, it starts solder
reversing.
If it receives this command while manual solder feeding is stopped, it ignores the
command.
1
2
3
4
5
STX
‘Ｒ’
ETX SUM
11.3.22 S : Manual Solder Reversing End
【Code】 ５３Ｈ(‘Ｓ’)
【Function】
Manual solder reversing end
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
If it receives this command while manual solder reversing, it stops manual solder
reversing.
If it receives this command during automatic solder feeding, it ignores the
command.
1 2 3 4 5
STX ‘Ｓ’ ETX SUM
11.3.23 T : Manual Air Blow Start
【Code】 ５４Ｈ(‘Ｔ’)
【Function】
Manual air blow start
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
It outputs air blow.
1
2
3
4
5
STX
‘Ｔ’
ETX SUM
11.3.24 U : Manual Air Blow End
【Code】 ５５Ｈ(‘Ｕ’)
【Function】
Manual air blow end
【Direction】
External controller → Soldering controller
【Data】
None
【Explanation】
It stops air blow output.
1
2
3
4
5
STX
‘Ｕ’
ETX SUM
