Revision 5 - 16 - November 2017
Chair/Resident Transfers into Tub
Before using the Level Glide™ Transfer System:
ü Carrier rails are aligned with tub rails.
ü Carrier latches securely to tub.
ü Chair locks to carrier.
ü Seat belts are installed properly.
Transferring Chair/Resident into tub…
Fasten seat belts by securing the belt over
white attachment knobs on back of chair.
Lower arm rests into the down position.
Ensure that chair is locked to carrier. Verify
the chair is slid all the way forward on carrier
and Primary Lock is engaged! The Chair
Tab should touch Stop Block. Verify that
Primary Lock touches bottom of Carrier
Rail to block the Chair Tab from moving
backwards.
Dock carrier to tub. Verify the carrier is secure
by pulling the carrier away from tub. The
carrier should not release from tub.
To Next Page
Loading...
Need help?
General
