Revision 5 - 9 - November 2017
Critical Warnings
Apollo Bathing Systems with the Level Glide™ Transfer System are designed and built to give
you years of reliable service. To realize the maximum benefits from your system, it must be
properly operated and maintained. This System Operating Manual gives you the information
needed for normal day-to-day resident bathing.
Hot water above 110° F (43° C) can scald people causing
severe injury or death. Some residents may not be able to
tell attendant about painful or uncomfortable conditions.
• Monitor water temperature entering the bathing system
and in the reservoir with thermometers provided.
Assure proper adjustment of the Level Glide™ Transfer
System and lock chair onto carrier to assure safe resident
transfer.
Before moving Level Glide™ Transfer System:
• Verify chair is locked to carrier.
• Properly secure resident to chair with upper and lower
seat belts.
• Be sure arm rests are in the down position.
• Never leave resident unattended in chair or tub.
Before transferring resident between carrier and tub or tub
and carrier:
• Be sure carrier rails are aligned with tub rails.
• Be sure carrier is latched securely to tub.
• Be sure arm rests are in the down position.
Failure to clean and disinfect the bathing system could help
to spread infection or disease.
Clean and disinfect bathing system and chair before
bathing each resident.
Do not leave water in reservoir between bathing sessions or
overnight.
To Next Page
Loading...
Need help?
General
