Revision 5 - 31 - November 2017
Whirlpool Cleaning Procedure
Your Apollo Advantage™ Bathing System arrived with an Advantage™ Intro Pack which
includes Turbo Clean™ Pre-disinfectant Chelating Detergent. Turbo Clean™ is used after each
bath to remove residue, bacteria and gross soils. Your Advantage™ Bathing System is calibrated
to dilute Turbo Clean™ at the exact mixture stipulated by the manufacturer’s instructions. Use of
other cleaners is not recommended and could compromise the overall process.
Whirlpool Bath Cleaning Process
Place the chair in the tub, release the carrier
from the tub, and close the door.
Close the Tub Drain. Turn the Selector Knob
to "TUB CLEANER" and the Control Knob to
"On.”
Turn the whirlpool on. After the Turbo
Clean™ mixture has come out of the jets for
about 30 seconds or when there is about 2
inches of cleaning solution in the foot well;
turn the Selector Knob to "Rinse."
Lift seat bottom off chair, (pull up from back
of seat). Use the cleaning solution to scrub the
tub, chair and underneath seat bottom. When
clear water comes out of all the jets, turn the
Turn the Control Knob to "Off" and open the
Tub Drain.
Use the shower wand to rinse the tub and chair.
To Next Page
Loading...
Need help?
General
