APPA 501 - Page 19

Data Logger
You can record a lot of reading to memory in a long
time, then analyze and plot graph. The meter can store
maximum 40,000[1] data in memory. The recorded
data amount shows on the secondary display.
The record rate can be set from 1 sec and 600 sec.
The error of timer is less than 3 seconds per hour.
To use data logger, move the blink cursor of menu to
LOG position, and press the ENTER button to enter
mode. In this mode, you can operate the below
options :
To exit memory save / load mode, press the CANCEL
button.
Press ENTER button to start data logger. The logger
automatically records at regular intervals. You can press
ENTER button to pause data logger, press again to
continue. To stop data logger, press CANCEL button
to return.
Press ENTER button to clear all data from memory.
You can press the ENTER button to review data from
memory. Press UP or DOWN button to select data.
Press the CANCEL button to return.
Press ENTER button to review the maximum data from
memory.
Data Logger Options
You can setup the record rate of logger.
Press UP or DOWN button to select rate.
Press the CANCEL button to return.
MAX
Press ENTER button to review the minimum data from
memory.
SAVE
RATE
LOAD
CLR
MIN
Note 1: In APPA 501, the max data is 20,000.
502
Memory Size 40000
Model
501
20000
501 / 502
EN
18