• Never attempt a voltage measurement with the test
lead inserted into the A input terminal.
• Disconnect circuit power and discharge all high-voltage
capacitors before testing resistance, continuity, diodes,
or capacitance.
Caution
!
Identify conditions and actions that could cause
DAMAGE the meter or equipment under test.
• Disconnect the test leads from the test points before
changing the position of the function rotary switch.
• Never connect a source of voltage with the function
rotary switch in resistance, diode, continuity, and
capacitance position.
• Do not expose Meter to extremes in temperature of
high humidity.
• Never set the meter in Ampere function to measure
the voltage of a power supply circuit in equipment that
could result in damage the meter and the equipment
under test.
!
Hazardous voltage
Risk of danger. Important information. See manual
DC (Direct Current)
Double insulated
Low Battery
Earth ground
AC (Alternating Current)
Conforms to EU directives
Do not discard this product or throw away.
Electrical Symbols
Fuse
CAT III
CAT IV
IEC Overvoltage Category
CAT III equipment is designed to protect against transients
in equipment in fixed equipment installations, such as
distribution panels, feeders and short branch circuits, and
lighting systems in large buildings.
CAT IV equipment is designed to protect against transients
from the primary supply level, such as an electricity meter
or an overhead or undergroundutility service.
501 / 502
EN
To Next Page
Loading...
