48
STAC6 Hardware manual
920-0029 Rev. B
11/19/2010
Mounting the Drive
You can mount your drive on the wide or the narrow side of the chassis using #6 screws. If possible, the
drive should be securely fastened to a smooth, at metal surface that will help conduct heat away from the
chassis. If this is not possible, then forced airow from a fan may be required to prevent the drive from
overheating.
• Never use your drive in a space where there is no air flow or where other devices cause
the surrounding air to be more than 55°C.
• Never put the drive where it can get wet or where metal or other electrically conductive
particles can get on the circuitry.
• Always provide air flow around the drive. When mounting multiple STAC6 drives near
each other, maintain at least one half inch of space between drives.
To Next Page
Loading...