User Manual – Electric Vehicle Charging Equipment IC-CPD
10
Version 1.0 / 1906
6. User benefits and features
This IC-CPD charging equipment allows you to
charge your battery-powered electric vehicle
(BEV) or plug-in hybrid electric vehicle (PHEV)
without any additional device. The user-friendly
plug system makes the vehicle connector fit
directly into the charging inlet of the vehicle and
the existing electrical infrastructure.
The IC-CPD charging equipment provides a
standard grounded power connection to residential
building sockets from 100 V to 240 V 50/60 Hz
(depending on the model variant) and a charging
current of 6 A up to 16 A according to the
specifications on the back label of the control box
of your device.
Vehicle cable:
• IEC 62196-1 Plugs, socket-outlets,
vehicle connectors and vehicle
inlets – Conductive charging of
electric vehicles –
Part 1: General requirements
• IEC 62196-2 Plugs, socket-outlets,
vehicle connectors and vehicle
inlets – Conductive charging of
electric vehicles –
Part 2: Dimensional compatibility
and interchangeability requirements
for a.c. pin and contact-tube
accessories
• Microswitch-based proximity switch
(exclusively for vehicle connectors
type 1 and GB/T page 11)
• Knurled knob for easy, slip-proof
locking control (exclusively for
vehicle connector type 1 and GB/T
page 11)
• Ergonomic rubber grip for optimal
support
• When the vehicle charging inlet
and grid socket are properly
connected, all terminal interfaces
and terminals are fully protected
against contact
• Temperature monitoring
• The IC-CPD continually monitors
the temperature inside the
power plug, so that any
over-heating under certain
conditions of the power plug
is avoided
CHARGING
TEMPERATURE
POWER
FAULT
To Next Page
Loading...
Need help?
General