Aqualisa Q User Manual

Warm up mode
*Warm Up mode is only available with Q
TM
EDITION, and is not recommended to use with combination
boiler water systems.
**Water Save is not suitable for use with combination boiler water systems, or in smaller shower enclosures.
ON OFF
Auto
wake up
RUN BOTH OUTLETS
AT WARM UP
For divert models only.
This feature expels cold
water from both outlets,
to avoid a cold shock when
diverting during
showering.
WATER OFF AT
END OF TIMER
If this is enabled, the
shower will shut down
when the timer reaches
zero. This is a global setting
and if activated will be
applied to all showers and
experience profiles that
have a timer parameter.
PAIR A REMOTE
If you have purchased a Q
TM
remote control, please
refer to the separate
instructions supplied.
Run both outlets
at warm up
Water o at
end of timer
Pair a remote
YES NO
Settings
WARM UP MODE*
When selected, after
starting the shower the
water will run until the
target temperature has
been reached. The water
will then stop and the
controller will be paused
until the Q™ lever is
pushed. The pause will time
out after two minutes.
Water save
WAKE UP
This setting allows the
Wake Up feature to be
turned o. This may be
required if you have a
small shower enclosure,
and Wake Up is
permanently active.
WATER SAVE**
This feature automatically
reduces the water flow to
Min Flow when you step
more than 0.5 metres
away from the controller,
(when washing your hair,
for example). This is a
good way to save water.
(See page 20 for details).
17

Aqualisa Q Specifications

General

Brand	Aqualisa
Model	Q
Category	Controller
Language	English