15-02-2019 Page 23 of 44 ARB Copyright 2019 3789507
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
4.8) Position the canopy rearward so the lower rear
door sash seal contacts the edges of the tub
corners above the brake lights on the tub evenly.
Measure with a ruler between the lower door sash
to the tub to ensure this is even on both sides.
4.9) Measure the trim edges of the canopy at the rear
sides and at the front both sides, to the vehicle’s
tub and make this measurement even on both
sides of the canopy. (Step 4.17 can assist to
achieve even gaps).
Look in the interior and ensure the mounting
holes in the steel mount rails on the canopy align
to holes in front tub corner mounting brackets
and the rear corner tub mounting brackets on
both sides of the vehicle.
4.10) Stand back and walk around the canopy and
check uniform balanced fit to the tub and cabin.
The canopy is central on the Ute body.
Alignment between cab and canopy is even
both sides
The rear door seals against the tailgate evenly
both sides without excessive force on glass to
close.
The gap is even between the door and shell on
both sides.
4.11) On both sides of the tub ensure the tailgate
when opening, clears the rear lower corner
edges of the canopy shell.
To Next Page
Loading...
