If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
4.43) With the tailgate down and door open, apply
neutral cure silicon up into the rear corner
tailgate sealing bracket areas, between the tub
lip edge at the tailgate end to the foam pad and
up between the foam pad and the seal on the
base rail of the canopy. Clean up excess and
smooth the silicon down.
4.44) Apply masking tape to the vehicle’s tailgate level
with the lower edge of the door sash.
4.45) Open the canopy’s door. Starting overlapped
about 10mm with one end of the tailgate, in the
location as shown, and above the line of the
masking tape which is to be used as a guide for
location. Roll out the clear protection tape
(665037) and start partially by removing the tape
backing liner and align the lower edge of it to the
top edge of the masking tape. Leave the
overhang on the opposite side.
4.46) During application of the clear tape, push out
bubbles and wrinkles working from one end of
the tape with a squeegee. Trim the clear tape
both ends level with the tailgate ends and
smooth off.
Remove the masking tape
To Next Page
Loading...
