15-02-2019 Page 7 of 44 ARB Copyright 2019 3789507
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
1.14) Move the protective board before cutting.
Carefully cut away any remaining metal not flush
with the top of the vehicle’s side tub rail panels.
1.15) Using metal files, de-burr the outer and inner
edges of the remaining portions of the cabin
guard support legs on the vehicle’s tub.
1.16) Using compressed air, completely blow out any
metal filings / swarf in the tray floor.
1.17) After removal, touch up the bare metal with
primer, and then fill any holes exposed from the
removal of the cabin guard with a neutral cure
silicone.
To Next Page
Loading...
