Arbortech AS170 - Maintenance of the Arbortech AS170; Motor Maintenance and Cleaning

Fig.10
“Hammering!”
Fig.11
“Hammering!”
Clearance
each end
Fig.12
When using the Mortar Plunge blades, the cut
should have enough clearance on each end
(showning:12),toensurethatnohammeringof
thebladeendsoccurs(asshowning.13).
“Hammering!”
Fig.13
7. MAINTENANCE
WARNING: To reduce the risk of serious personal
injury,turnthetooloffanddisconnecttoolfromthe
powersourcebeforemakinganyadjustmentsor
removing/installing attachments or accessories.
Before reconnecting the tool, depress and release
the trigger switch to ensure that the tool is turned
off.
To assure product SAFETY and RELIABILITY,
repairs,maintenanceandadjustment(including
brush inspection and replacement) should be
performed by an ARBORTECH authorised service
center. Always use identical replacement parts.
7.1 Motor
Cleaning
CAUTION: Blowing dust and grit out of the motor
and switch actuator using clean, dry compressed
air is a necessary regular maintenance procedure.
Dust and grit particles often accumulate on interior
surfaces and can cause premature failure. Not
regularly cleaning the AS170 will affect the tools
warranty.
CAUTION: ALWAYS WEAR SAFETY GLASSES
when using or cleaning this tool.
Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. Use a
clean, dry cloth only.
Lubrication
ARBORTECH tools are properly lubricated at the
factory and are ready for use.
Accessories
eNGLISH 9
E
N
G