USER MANUAL ARC
LAST UPDATED: 6/01/2017 22
This section will detail some of the operation of the conversion. To activate the
motor ensure that the battery is connected and the throttle button has been
switched on. The motor can now be actuated through pedalling or utilising the
throttle.
OPERATION
Charging the battery is a simple process and can be completed with the battery
mounted to the bicycle or when the battery has been removed from the electric
bike.
OPERATION—BATTERY CHARGING
Follow the following steps:
Plug the charger into the wall socket
Locate the charger plug on the base of the frame near the folding joint.
Shown on the left of the middle picture.
Plug in the charger to the battery.
The charger LED light will turn red while charging and green once nished
charging.
Unplug the charger from the battery and the wall socket once charging is
complete.
If charger does not stop charging after the charge time indicated in the bike
description. Disconnect the charger and contact support.
To calculate charge time: Capacity of battery (Ah) divided by the charge current
(A) = hours to charge. Usually 10.4Ah/2A = ~5 hours
To Next Page
Loading...