USER MANUAL ARC
LAST UPDATED: 6/01/2017 8
This section will detail some of the basic step you will need to undertake to
prepare your bicycle for conversion.
ASSEMBLY—BICYCLE PREPERATION
First thing you will need to do is nd a suitable space for you to complete the
installation in. If you don’t have a nice soft surface to ip the bike over onto (or
don’t have a bike maintenance stand) then we recommend that you utilise some
of the foam that comes in the kit to prevent any damage to your bike.
As pictured, we have ipped the bike over in preparation for removing the front
wheel to mount the motor. In this particular case the front wheel was quick
release making it very easy to remove without tools. Though you may require a
spanner/shifter at this stage to remove the front wheel.
To Next Page
Loading...