USER MANUAL ARC
LAST UPDATED: 6/01/2017 9
Once the wheel has been removed, if your bicycle has a front disk brake. Then you
will need to remove that disk brake to mount onto the front motor.
ASSEMBLY—BICYCLE PREPERATION
Some disk brakes may require specialist tools to remove. Though most will only
require a standard 5mm allen key. Once you have removed the disk brake place it
aside for the next step.
Unless you purchased a new tyre and tube to go with the new motor, you will also
require the front tyre and tube to removed so that you can relocate it to the hub
motor from the conversion kit. Deate the tyre and remove the tyre and tube. This
usually can be done by hand though may require some tyre levers to help get the
job done. Avoid using tyre levers if possible though as they will increase your
chances of creating an accidental puncture in the tube. Just start on the opposite
side of the tubes valve, removing the tyre from the rim and work your way around
until the tyre is completely removed.
To Next Page
Loading...