Arcam A90 User Manual

A90/P90
12
A90/P90
13
English
Remote-control codes
The following table gives the IR-commands accepted by the
A90.
Power commands
Command Decimal Code
Power toggle 16–12
Power-on 16–123
Power-off 16–124
Source selection commands
Command Decimal Code
PHONO select 16–1
AV select 16–2
TUNER select 16–3
DVD select 16–4
TAPE select 16–5
VCR select 16–6
CD select 16–7
AUX select 16–8
Volume control commands
Command Decimal Code
Mute 16–13
Volume up 16–16
Volume down 16–17
Menu navigation commands
Command Decimal Code
UP
16-32
DOWN
16-33
SELECT
16–37
ENTER
16–87
Speaker control commands
Command Decimal Code
Speaker 1 toggle 16–35
Speaker 2 toggle 16–39
Speaker 1 on 16–43
Speaker 1 off 16–44
Speaker 2 on 16–45
Speaker 2 off 16–46
Display control commands
Command Decimal Code
Display 16–59
Note that the A90 also responds to code 20–53 (the Play
command for an Arcam CD player). The A90 swiches
automatically to CD input on receiving this command.

Arcam A90 Specifications

General

Frequency Response	20Hz - 20kHz
Total Harmonic Distortion	0.02%
Signal to Noise Ratio	100dB (A-weighted)
Dimensions	430mm
Input Impedance	47kΩ