Arcam CR100 - TUN Mode

English
CR100
E-11
TUN mode

Toggles power between
stand-by and on.
�
to
�
Functions as original
remote number key.

Selects Tape input on
amplier

Selects FM band

Modies many keys (see
individual key descriptions,
below)

Selects multichannel
(MCH) input on amplier

Selects AM band
Navigate setup and
programme selection
menus. OK conrms a
selection.
SHIFT
B
to Power on
SHIFT
C
to Power off
Conrms a setting
(equivalent to ‘Enter’ or
‘Select’ on some remotes)

Cycles through different
frequency bands.

Functions as original
remote key, if available

Cycles through the front
panel display’s brightness
options (dim to bright, off)
Toggles the mute function,
if available.
By default this key always
operates the AMP Mute.
Sends Preset Down
command
Sends Preset Up command
Decrease (–) and increase
(+) amplier volume
Fast rewind (DAB rewind
radio)
Play (DAB rewind radio)
Toggles pause of playback
(DAB rewind radio)
Fast forward (DAB rewind
radio)
Selects FM band on the
DAB tuner
Stops playback (DAB
rewind radio)
Start recording (DAB
rewind radio)

Selects DAB band on the
DAB tuner

Toggles FM tuner mode
between FM Mute mode
and Mono mode on Arcam
Receivers and Tuners.

Toggles between Preset
and Tune mode on Arcam
Receivers and Tuners.

Stores tuner preset on
Arcam Receivers and
Tuners.

Cycles through RDS radio
display modes for Arcam
Receiver and Tuners.