Arcam CR100 - AUX Mode

English
CR100
E-13
AUX mode

Toggles power between
stand-by and on.
�
to
�
Functions as original
remote number key.

Selects Tape input on
amplier

(not used)

Modies many keys (see
individual key descriptions,
below)

Selects multichannel
(MCH) input on amplier

(not used)
Navigate setup and
programme selection
menus. OK conrms a
selection.
Conrms a setting
(equivalent to ‘Enter’ or
‘Select’ on some remotes)
Behaviour of all other CR100 keys
in AUX mode depends on the type
of auxiliary device. Refer to the
appropriate table for the device.
By default, AUX mode has been set
up for future ARCAM products.
The AUX control page can be
assigned for use with a DVD or VCR
player using the following method:
1. Unlock the code page (this is
described on page 18 – ‘Locking/
Unlocking a specic device
mode’).
2. The functions of AUX mode can
now be replaced by those of a
DVD or VCR by changing the
four-gure device code (this
is also explained on page 18
– ‘Mode Mover’).
3. Now lock the mode so the
new settings are not changed
inadvertently.