English
CR100
E-3
The CR100 is a sophisticated
‘universal’ remote control that can
control up to eight devices.
<
The CR100 is preprogrammed for
use with Arcam products (Solo
Movie, ampliers, multi-channel
sound processors, CD players and
DVD players) within range.
SEE PAGES 8–15...
<
The CR100 can control your
complete home entertainment
system. With its extensive built-in
library of codes, the CR100 can
be used with thousands of third-
party TVs, satellite decoders, set-
top boxes, VCRs and CD players.
SEE PAGES 6, 21...
<
The CR100 can ‘learn’ almost any
function from an old single-device
remote.
SEE PAGE 16...
<
You can customise the CR100
to suit, and program it to issue
a sequence of commands (a
‘Macro’) at a single key press.
SEE PAGES 16, 19...
The CR100 is supplied with several
Arcam products �or specic products �or specic
information on how to use the CR100
to control the product it was supplied
with, please refer to that product’s
manual.
Device Mode keys
The Device Mode keys (shown below)
select the source on your amplier,
preamplier or receiver These keys
also change the functionality of the
remote control. It’s like having eight
different remotes in your hand!
If you press and hold a Device Mode
key, you change the Device Mode
without changing the signal source.
Each Device Mode changes the
behaviour of many of the CR100 keys
to control the source appropriately
(see pages 8–15). For example:
<
In
To Next Page
Loading...