Arcam FMJ MS250 - Technical Specifications; General and Audio Specs; Digital Audio and Video Output Specs; Supplied Accessories and Policy

MS250
34
Technical specications
General
Power Requirements Within the range 115V to 230V AC
Power consumption < 35 VA
Dimensions 435mm x 80mm x 350mm
Weight net: 5.2kg; packed: 8.0kg
Audio outputs
Analogue audio outputs Four zones of stereo output on gold-plated phono sockets
Output level 2.2V rms at 0dB signal
Frequency response 20Hz to 20kHz (+0.1db, –0.5dB)
THD+N <0.005% for 1kHz 0dB signal,
measured 22Hz–22kHz, unweighted
Signal-to-noise ratio 105dB, measured 20Hz–20kHz, unweighted
Digital audio output (IEC958) PCM on gold-plated phono (coax) and TOSLINK (optical) sockets
Video outputs
Composite video 1 x gold plated phono. 1V pk-pk in 75Ω
S-Video 1 x 4-pin mini-DIN. Y 1V pk-pk in 75Ω, C 0.3V pk-pk in 75Ω
VGA SVGA output (800 x 600 pixels, up to 16 million colours)
1 x 15-pin D-subminiature VGA connector
Accessories supplied
CR-425 Remote control
2 x AAA batteries
mains lead
E&EO
NOTE: All specication values are typical unless otherwise stated.
Continual improvement policy
Arcam has a policy of continual improvement for its products. This means that designs and
specications are subject to change without notice.