Arcam SA35 - Connecting Loudspeakers; Wired Network Connection; Connecting Speakers

6
ARCAM SA35 OM EN V2
CONNECTING SPEAKERS
AND A WIRED NETWORK
HF
LF
HF
LF
DIG 3 DIG 4
PRE
OUT
SUB2
SUB1
CLASS 2 WIRING
Connecting Loudspeakers
Step 1, ensure power is disconnected from the amplifier.
Step 2, using speaker cables, connect the red positive terminal of the right speaker output (R+) on the
amplifier to the positive (+) terminal of your right speaker.
Step 3, connect the black negative terminal of the right speaker output (R-) on the amplifier to the negative (-)
terminal of your speaker.
Step 4, repeat the process for the left speaker, using the terminals labelled L+ and L- and on the amplifier.
Top Tips
| Check all connections thoroughly. Ensure that exposed wires or cables are not touching each other or the
amplifier’s chassis (which can cause a short circuit), and that you have connected the positive (+) and
negative (–) terminals correctly. Be sure to check the wiring for both the amplifier and the speakers.
| After making connections: switch the amplifier on with no input and reduce the volume to minimum.
Select a source signal, and then slowly increase the volume to a suitable listening level to avoid loud
sounds or product damage in the event of incorrect connection.
| If you are unsure as to how your system should be connected, please contact your ARCAM dealer who will
be happy to help you.
Wired Network Connection:
DIG 1
DIG 2 DIG 3 DIG 4
100-120V/220-240V ~
50/60Hz
1000W MAX
POWER INLET
BALANCED INPUTS
BALANCED OUTPUTS
PHONO
(MM)
AN 1
R L SUB1 SUB2
L
R
AN 2 AN 3LR AN 4
PHONO
(MC)
PRE
OUT
SUB2
SUB1
IR IN
USB NETWORK CONTROL
HDMI eARC
CLASS 2 WIRING
100-120V/220-240V ~ 50/60Hz
700W MAX
POWER INLET
DIG 1
DIG 2 DIG 3 DIG 4
PRE
OUT
SUB2
SUB1
PHONO
(MM)
PHONO
(MC)
IR IN
USB NETWORK CONTROL
HDMI eARC
CLASS 2 WIRING
100-120V/220-240V ~ 50/60Hz
15W MAX
POWER INLET
COAX
OUT
OPTICAL
OUT
TRIGGER
OUT
NETWORK
CONTROL
USB
Ethernet Socket
Connect this to your home network
using a Cat 5e or Cat 6 cable