12 /37 EN
Refrigerator / User Manual
4.1. Things to be done
for energy saving
A
Connecting the product to electric energy
saving systems is risky as it may cause
damage on the product.
• Do not leave the doors of your refrigerator open
for a long time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload the refrigerator, cooling
capacity will fall when the air circulation inside
is hindered.
• In order to store maximum amount of food
in the freezer compartment, the icematic,
available in the freezer compartment and
easily removable by hand, shall be taken
out. Net volume and energy consumption
values declared on the power data plate of
your refrigerator are measured and tested
by removing the icematic. Do not remove the
shelves inside the freezer compartment and on
the door of freezer compartment shall not be
removed and they shall always be used they
provide ease of use and efficiency in energy
consumption.
• Airflow should not be blocked by placing foods
on the sides of the freezer compartment fan.
A minimum distance of 3 cm shall be provided
on the sides of protective fan cover.
• The baskets/drawers that are provided with the
chill compartment must always be in use for
low energy consumption and for better storage
conditions.
• Food contact with the temperature sensor in
the freezer compartment may increase energy
consumption of the appliance. Thus any
contact with the sensor(s) must be avoided.
• Depending on the features of your product,
thawing frozen food in fridge compartment will
both provide energy saving and preserve the
food quality.
• Do not allow contact of the food with the fridge
compartment temperature sensor shown in the
figure below.
4.2. Initial use
Before starting to use your refrigerator, ensure that
all preparations are made in accordance with the
instructions in sections "Instructions for safety and
environment" and "Installation".
4 Preparation
• Run the product without putting any food for 6
hours and do not open its door unless certainly
required.
C
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running and this is quite normal.
C
Front edges of the product may feel warm.
This is normal. These areas are designed
to be warm to avoid condensation.
C
In some models, the instrument panel
automatically turns off 5 minutes after
the door has closed. It will be reactivated
when the door has opened or pressed on
any key.
To Next Page
Loading...
Need help?
General
