11/35EN
Refrigerator / User Manual
4 Preparation
t Since hot and humid air will not directly
penetrate into your product when the
doors are not opened, your product will
optimize itself in conditions sufficient to
protect your food. In this energy saving
function, functions and components
such as compressor, fan, heater, defrost,
lighting, display and so on will operate
according to the needs to consume
minimum energy while maintaining the
freshness of your foodstuff.
t In case of multiple options are present
glass shelves must be placed so that
the air outlets at the backwall are not
blocked, prefably air outlets are remaining
below the glass shelf. This combination
may help impoving air distribution and
energy efficiency.
4.2. Initial use
Before starting to use your refrigerator,
ensure that all preparations are made in
accordance with the instructions in sections
"Instructions for safety and environment"
and "Installation".
t Run the product without putting any
food for 6 hours and do not open its door
unless certainly required.
C
)9?A3662/+<+893=/A2/8>2/
compressor starts up. The liquids and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
C
Front edges of the product may feel
warm. This is normal. These areas
are designed to be warm to avoid
condensation.
C
In some models, the instrument
panel automatically turns off 5
minutes after the door has closed. It
will be reactivated when the door has
opened or pressed on any key.
To Next Page
Loading...
