Dishwasher / User’s Manual
11 / 53
EN
Installation
C
Drainpipe must be
connected to the sewage
system and it should not be
connected to any surface
water.
If the door of the product cannot be
closed properly or if the product swings
when you push it slightly, then you need
to adjust the feet of the product. Adjust
the feet of the product as illustrated in
the installation manual supplied with the
product.
A
Dishwashers door must be
aligned properly otherwise
hot steam can escape!
Danger of serious burns,
other injury or may damage
furniture.
Connect the product to a grounded
outlet protected by a fuse complying
with the values in the “Technical
specifications” table. The manufacturer
shall not be liable for any damages
that will arise when the product is used
without grounding in accordance with the
local regulations.
• Connection must comply with
national regulations.
• Power cable plug must be within
easy reach after installation.
B
Unplug the product after the
washing programme is over.
• The voltage and allowed fuse or
breaker protection are specified
in the “Technical specifications”
section. If the current value of the
fuse or breaker in the house
is less than 16 Amps, have a
qualified electrician install a 16
Amp fuse.
• The specified voltage must be
equal to your mains voltage.
• Do not make connections via
extension cables or multi-plugs.
B
Damaged power cables
must be replaced by the
Authorised Service Agent.
B
If your dishwasher is
equipped with internal
illumination, lamp should
only be replaced by the
Authorised Service Agent
in case of failures that may
occur on the lamp.
B
If the product has a failure,
it should not be operated
unless it is repaired by the
Authorised Service Agent!
There is the risk of electric
shock!
Before starting to use the product,
make sure that all preparations
are made in accordance with the
instructions in sections “Important
safety instructions” and “Installation”.
• To prepare the product to do the
dishes, perform first operation
in the shortest programme with
detergent while the machine is
empty.
A
There might be a small
amount of water left in the
product after factory quality
control tests. This has no
harm on the product.
To Next Page
Loading...
