EasyManua.ls Logo

arcelik 9252 MI - Cancelling the Programme; Salt Indicator ( ); Rinse Aid Indicator ( ); Adjusting the Amount of Rinse Aid

arcelik 9252 MI
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44 Dishwasher / User’s Manual/53 EN
Operating the product
C
Pay attention not to open the
door of the machine when it
is running. Stop the machine
by pressing Start/Pause/
Cancel key if you have to
open the door. Then, open
the door of the machine.
There may be a rush of
vapour when you open the
door of your machine; be
careful. Close the door of
your machine and press
Start/Pause/Cancel key
again. Programme will
resume running.
C
The machine will remain
silent in pause mode for
some time in order to
remove the water in the
machine and on the dishes
completely and to have the
water softener cleaned, and
then it will resume running in
drying mode.

1. Press Start/Pause/Cancel key for 3
seconds to cancel the programme.
2. Release the key when the
programme indicator starts
flashing. For a couple of minutes
the machine will fulfill the
necessary operations required to
cancel the programme.
C
There might be residues
of detergent or rinse aid
in the machine and/or on
the pieces being washed
depending on the step
the programme you have
cancelled was in.

Please check the salt indicator on
the display to see whether there is
adequate amount of softening salt
in the dishwasher or not. You need
to refill the salt reservoir with salt
whenever salt indicator appears on the
display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.

Please check the rinse aid indicator
on the display to see whether there is
adequate amount of rinse aid in the
dishwasher or not. You need to refill
the rinse aid reservoir with rinse aid
whenever rinse aid indicator appears
on the display of your machine.
󰀬

1. After turning on the machine,
press and hold Time Delay and P keys
simultaneously for 3 seconds to enter
the settings menu.
2. Press P key until the drying
indicator starts flashing
3. Set to the appropriate level with the
Time Delay key.
4. Press the On/Off key to save.
No rinse aid dispensed in P:1 position
1 dose of rinse aid is dispensed in P:2
position.
2 doses of rinse aid are dispensed in
P:3 position.
3 doses of rinse aid are dispensed in
P:4 position.
4 doses of rinse aid are dispensed in
P:5 position.

Table of Contents

Related product manuals