Dishwasher / User’s Manual
45 / 53
EN
Operating the product
End of Programme indicator will light
up once the washing programme is
over.
1. Press the On/Off key to turn off
your machine.
2. Close the tap.
3. Unplug the machine from the
socket.
C
For energy saving, the
machine is automatically
turned off following
the completion of the
programme or if the
programme is not started.
C
Leave your dishes in the
machine for about 15
minutes to allow them cool
down after they are washed.
Your dishes will dry in a
shorter time if you leave
the door of your machine
ajar during this period. This
process will increase the
drying effectiveness of your
machine.
If mains water is cut or water inlet
tap is turned off the machine cannot
take water in and P2 icon will flash
on the programme indicator. As long
as the problem continues, washing
programme is paused and the water
inlet is checked regularly by the
machine; when the water is restored
P2 icon will disappear after a while and
the washing programme resumes.
If the machine intakes too much
water or there is leakage at any of the
components then the machine will
detect this and P1 icon will flash on the
Programme indicator. As long as the
overflowing continues safety algorithm
will be active and try to discharge the
water. If overflowing stops and safety
is assured, P1 icon will disappear.
If P1 does not disappear, there
is a permanent fault. In this case
the authorised service should be
contacted.
To Next Page
Loading...
