Dishwasher / User’s Manual
13 / 53
EN
Preparation
After determining hardness level of the supply water:
1. Turn on the machine, press and hold Time Delay and Programme keys
simultaneously for 3 seconds to enter the settings menu.
2. Press the programme key until the Salt indicator starts to flash. Current
regeneration stage is displayed on the programme indicator.
3. Using Time Delay key, adjust water hardness level according to the hardness of
the supply water. See “Water hardness level adjustment table” for correct setting.
4. Press On / Off key to save the setting.
Hardness
Level
English Water
Hardness °dE
German Water
Hardness °dH
French Water
Hardness °dF
Water Hardness Level Indicator
0th Level
0-5 0-4 0-8
Press the Time Delay key to switch the water hardness level
to position P1.
1st Level
6-9 5-7 9-13
2nd Level
10-15 8-12 14-22
Press the Time Delay key to switch the water hardness level
to position P2.
3rd Level
16-19 13-15 23-27
Press the Time Delay key to switch the water hardness level
to position P3.
4th Level
20-24 16-19 28-34
Press the Time Delay key to switch the water hardness level
to position P4.
5th Level
25-62 20-50 35-90
Press the Time Delay key to switch the water hardness level
to position P5.
IIn order to protect your glassware against glass corrosion in an optimal way, you
have to perform the same hardness settings, which you have made in the control
panel, with the regeneration setting switch.
For example, if you have adjusted to “3rd level” in the control panel, also set the
regeneration adjustment switch to 3rd level.
Regeneration Adjustment Switch
0th Level 1st Level 2nd Level 3rd Level 4th Level 5th Level
1 1 2 3 4 5
If the hardness level of the supply water is above 90 °dF or if you are using well
water, then it is recommended to use water purification devices and special filters.
If the hardness level of the supply water is below 13°dF, there is no need to use
salt in your dishwasher. If this is the case, “No Salt Warning Indicator” (if any)
illuminates continuously on the panel of your machine.
If the water hardness level adjustment is set to level 1, the “No salt warning
To Next Page
Loading...
