72-DVTE30-2
36
WARNING : If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life. Do not
operate the appliance with the glass front removed, cracked or broken.
Replacement of broken glass should be done by a licensed or qualified
service person.
LIGHTING INSTRUCTIONS - CAUTION
When operated for the first few times, the appliance will emit some odor and fumes. This is due
to the heat from the appliance evaporating the oils and solvents used in fabricating the
appliance. Close off the room to the rest of the house and open all windows. Keep the room
well ventilated as smoke alarm may sound. Run the appliance for at least 6 hours at maximum
setting with blower set to “OFF” to allow paint to cure (after the installer has checked to ensure
the fan is operational). Smoke and fumes caused by the curing process may cause discomfort
to some individuals.
FIRST FIRE
1. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next
to the floor, because some gasses are heavier than air and will settle on the floor.
2. IF YOU SMELL GAS, follow the instructions as listed directly above or as shown on the
front cover of this manual.
3. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system
and any gas control which has been under water.
4. This appliance is equipped with an ignition device which automatically lights the pilot and
main burner. The pilot and burner light automatically with the hand held remote or with
the switch behind the louvers if it is activated.
To Next Page
Loading...
