Arcom Digital Quiver XT - Node Connection - Isolation at Fiber Node

Arcom Digital Quiver XT

80 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

16

Node Connection – Isolation at Fiber Node

Table of Contents

Default Chapter2
- Table of Contents2
Introduction4
Quiver Functional Overview4
Navigation Buttons5
- Inputs and Outputs6
- Batteries6
Startup7
Brightness and Audio Control7
Settings8
Settings - General8
- Setting up the FSK Data Carrier Band and FSK Frequency9
- Background10
Settings - Measurement10
- Setting Operation Standards10
- Distance Scale11
- Return Band11
- FWD Scan List11
- Sweep Profile12
Settings - Calibration12
Quiver XT Operation Modes13
CPD Radar Mode13
- Passive CPD Radar14
- CPD Radar Connection Diagrams15
- Amplifier Connection17
- Tap and Splitter Connection18
- End of Line CPD19
- Using CPD Radar in Local View20
- Selecting CPD Detection Filter Bandwidth21
- Selecting Noise Suppression21
- Using the CPD Marker Option23
- Zoom Mode in Passive Radar24
- Filtering of Analog Channels - IMPORTANT25
- Active Radar Mode25
Ntc Tdr26
- Connecting to a Line Passive29
- Connecting to an Amplifier30
- Connecting to a Length of Cable31
- Using the TDR32
- Check Spectrum32
- TDR Settings - VOP33
- Cable33
- Recommended TDR Signal Level34
- TDR Run Modes34
Spectrum Analyzer/Signal Level Meter Modes35
- Return Spectrum Analyzer Mode35
- LNA - Low Noise Amplifier37
- Reference Level Change37
- Scale Change38
- Markers39
- Using Max Hold40
- Hold Feature41
- Saving a Spectrum Analyzer Trace41
Forward Slm/Spectrum Mode43
- Examples of Actual FWD Spectrum Signals43
QAM Demodulator Mode45
Using the Save Trace Option46
- Saving a Trace46
- Recalling a Trace47
- Clearing Traces48
- Downloading Traces48
- Using CPD Radar in Headend View49
Calibrator Mode (QVR-XT Only)50
Calibrator Connection Diagrams51
- Nodes51
- Alternative Node Calibration52
Using Calibrator Mode53
- Setting up the Data Carrier Frequency54
- Setting the Signal Output Level56
- Calibrating a Fiber Node57
- Turning Calibrator Output Signal on and off57
Leakage Detector60
- Max Hold Leak Level62
- Saving and Recalling the Leakage Trace63
RTN Simple Sweep Generator63
- Sweep Profiles64
- Manual Sweep Profile64
- Fixed Sweep Profile65
- Creating a Fixed Sweep Profile65
- Transferring a Fixed Sweep Profile Using Q-Browser66
Quiver Navigator App67
- Loading Maps into Your Quiver Navigator App67
QR Codes69
- Using the QR Code with the Mobile Quiver Navigator App71
Changing the Quiver-XT Battery Pack76
Changing the Q-AMP Battery77
Quiver-XT-UB Specifications78
- Physical78
- Environmental78
- Interfaces78