Arcom Digital Quiver XT - Amplifier Connection for CPD Location

Arcom Digital Quiver XT

80 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

17

Amplifier Connection

Node Connection – Isolation at Amplifier

Table of Contents

Default Chapter2
- Table of Contents2
Introduction4
Quiver Functional Overview4
Navigation Buttons5
- Inputs and Outputs6
- Batteries6
Startup7
Brightness and Audio Control7
Settings8
Settings - General8
- Setting up the FSK Data Carrier Band and FSK Frequency9
- Background10
Settings - Measurement10
- Setting Operation Standards10
- Distance Scale11
- Return Band11
- FWD Scan List11
- Sweep Profile12
Settings - Calibration12
Quiver XT Operation Modes13
CPD Radar Mode13
- Passive CPD Radar14
- CPD Radar Connection Diagrams15
- Amplifier Connection17
- Tap and Splitter Connection18
- End of Line CPD19
- Using CPD Radar in Local View20
- Selecting CPD Detection Filter Bandwidth21
- Selecting Noise Suppression21
- Using the CPD Marker Option23
- Zoom Mode in Passive Radar24
- Filtering of Analog Channels - IMPORTANT25
- Active Radar Mode25
Ntc Tdr26
- Connecting to a Line Passive29
- Connecting to an Amplifier30
- Connecting to a Length of Cable31
- Using the TDR32
- Check Spectrum32
- TDR Settings - VOP33
- Cable33
- Recommended TDR Signal Level34
- TDR Run Modes34
Spectrum Analyzer/Signal Level Meter Modes35
- Return Spectrum Analyzer Mode35
- LNA - Low Noise Amplifier37
- Reference Level Change37
- Scale Change38
- Markers39
- Using Max Hold40
- Hold Feature41
- Saving a Spectrum Analyzer Trace41
Forward Slm/Spectrum Mode43
- Examples of Actual FWD Spectrum Signals43
QAM Demodulator Mode45
Using the Save Trace Option46
- Saving a Trace46
- Recalling a Trace47
- Clearing Traces48
- Downloading Traces48
- Using CPD Radar in Headend View49
Calibrator Mode (QVR-XT Only)50
Calibrator Connection Diagrams51
- Nodes51
- Alternative Node Calibration52
Using Calibrator Mode53
- Setting up the Data Carrier Frequency54
- Setting the Signal Output Level56
- Calibrating a Fiber Node57
- Turning Calibrator Output Signal on and off57
Leakage Detector60
- Max Hold Leak Level62
- Saving and Recalling the Leakage Trace63
RTN Simple Sweep Generator63
- Sweep Profiles64
- Manual Sweep Profile64
- Fixed Sweep Profile65
- Creating a Fixed Sweep Profile65
- Transferring a Fixed Sweep Profile Using Q-Browser66
Quiver Navigator App67
- Loading Maps into Your Quiver Navigator App67
QR Codes69
- Using the QR Code with the Mobile Quiver Navigator App71
Changing the Quiver-XT Battery Pack76
Changing the Q-AMP Battery77
Quiver-XT-UB Specifications78
- Physical78
- Environmental78
- Interfaces78