65
Fixed sweep profile
Fixed sweep profile allows for multiple sweep
profiles to be pre-stored in the Quiver-XT. A
stored profile can be selected from menu option
2. The illustration on the right shows that profile
#1, out of two profiles present (#1 (2)) has been
selected. Each profile consists of 64 frequency
points between 5MHz and 90 MHz.
1.TX Level
: Select this option to change the
output from +10 to +35 dBmV
2.Sweep profiles
: used for selecting pre-set
sweep profile.
3.
Sweep time
: Allows you to adjust the sweep
time from 5mS to 10 mS.
Markers
: allows the technician to use two 1 or
2 markers. Markers can be set to Maximum peak,
manual adjustment (<>), or off.
Creating a fixed sweep profile.
A fixed sweep profile is simply a formatted
text file transferred into the Quiver using the Q-
browser program.
The file format is as follows:
Line 1, File Title
Lines 2 – 65, Point#, :,
space
, frequency point
(MHz) including one decimal (100 KHz).
Profile filenames must be in the format
Profile#.txt.
Where # is a sequential file number. Duplicate
numbers will be overwritten without notification.
To Next Page
Loading...