9
Setting Up the FSK Data Carrier Band and FSK frequency
This section is only applicable for the standard version of the Quiver XT and can be
disregarded when using the Unbundled version
.
Quiver uses an FSK carrier to communicate with headend equipment. Prior to
operating the system, you must set the frequency of the data carrier. The FSK carrier is
tuned in a relatively small bandwidth, which means that the Quiver is dedicated to one
particular headend or hub at a time. Any time you move to another headend or hub,
you must go back and change the Data Carrier.
When starting the Quiver for the first time, the user might have to select the FSK
band first. Typically, the Quiver will be set in the factory to the required band. Note
that the frequency band is factory preset with the hardware components and changing
the band in the settings will not have any result.
If it becomes necessary to verify if the Quiver is set to proper band, that can be
done in Settings mode – from the Operation
Modes, use the Setting soft key
Note: the selected FSK band must match
the internal FSK receiver band.
To Next Page
Loading...