Arctic Spas Y Series - Page 23

22

 Series Techoo
ae an error
messages F
  etc.
appeared on
epad displa
yes
no
erify if low-level
programming is set
properly.
Does the Pump 1
indicator appear
on the epad
displa hen ou
press the Pump
 e
efer to specic
section indicated
b error message.
yes
no
Replace
keypad.
no
Replace
Pump 1 fuse.
s there still a
problem
s Pump 
oring
in either
speed
yes
If still not
working
replace
spa pack.
no
Measure
voltage on
the board
for both
speeds.
Do ou
get a 
 reading
or  
for a 
 pump
for both
speeds
Problem
solved.
yes
no
Replace
Pump 1 if
needed.
Replace
spa pack.
yes
f Pump 1 is not working,
follow this troubleshooting ow chart:

Pump 1 does not work
 Check for an error
message on keypad
display. If there is one,
refer to the specific sec-
tion indicated by the
error message.
 erify low-level
programming
configuration.
 If the Pump 1 indicator does not appear, use a spare
keypad to verify if keypad is defective.
If it is, replace keypad.
If not, replace spa pack.
 If Pump 1 indicator appears when Key 1 is pressed,
verify if pump works in either speed.
 erify if the Pump 1
indicator appears on
keypad display when
you press Key 1.
Pump 1 doesnt work / ow chart  stepbystep
Flow chart
StepbyStep
Troubleshooting
Check
wiring and
plugs.
Replace if
needed.