BXT3-V2.3
ARCURE SA – 14, rue Scandicci – 93500 Pantin – France - Tel.: +33 144 068 190
www.arcure.net
09/05/2019 16/41
4.3.2 Sensor head cleaning (at least once a day)
To ensure optimum performance, both lenses of the sensor heads should be
cleaned at least once a day (If the mirrors need cleaning, so will the sensor
heads!).
Clean the lenses at least once a day with a soft cloth. Products for washing
windows and water may be used.
After cleaning, make sure that the windows are:
• Dry, free of dirt and drops;
• Without scratches. In case of significant scratches, contact your
installer or Blaxtair’s customer support.
4.3.3 System setup (if necessary)
During installation, the system was set up for optimum performance.
If the sensor head has been moved from its initial position or suffered an
impact, performance will be degraded.
If the sensor head has received an impact of any kind,
the system must be checked ref: section 4.3.1 .
It in any doubt the system must be inspected by a
Blaxtair certified engineer.
4.4 Driver Periodical training
Before working with a machine equipped with BLAXTAIR®, operators should
be specifically trained as to its use and maintenance.
He/she shall be updated on a regular basis regarding:
• His/her own responsibilities (see warning. chapter 2);
• System operation and limitations (chapter 4);
• Precautions for use (section 4.1);
• Maintenance operations he/she is responsible for (section 4.3).
To Next Page
Loading...
