17
fig. 2
fig. 3
fig. 4
fig. 5
2. Set up inside Lever: Put Lever on Lever Spindle then use Allen Wrench to put Allen Screw
(see fig. 5). Use Allen Wrench to take Allen Screw off then pull out Lever when you want to
remove Lever.
3. Set up outside Lever: You may set up lever to fit for either left-handed or right-handed door.
3.1 Make sure that the dent is on 12-clock position when lock hasn’t be installed on the door
(see fig. 1), if not, rotate Square Spindle.
3.2 Rotate inner Spindle by Flathead Screwdriver let Cylindrical Protrusions horizontally
aligned (seefig. 6).
3.3 Insert Lever Catch in the right side hole on Lever Spindle completely if your door is
left-handed (see fig. 7a), otherwise put it in the left side hole (see fig. 8a). The big end on the
Lever Catch goes into the hole first.
To Next Page
Loading...
