!! ! Installation!Manual!
Page | 15 support@arecontvision.com
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
Allows the user to choose the specific time of video to playback.
Button to play video specified in the Playback field.
Allows the user to continuously record without restriction.
Default is unchecked box.
Stop Continuous
Recording AND Enable
Event-triggered
Recording
Allows the user to enable events recording when network
failure, motion alarm, or an I/O alarm is triggered. Default is
unchecked box.
NOTE: if the continuous recording is disabled and no event
recording is enabled, the SD card will not initiate recording.
Allows the SD Card to record video only in the event that the
network fails.
Allows the SD Card to record video only in the event that motion
is detected.
Allows the SD Card to record video only in the event that an I/O
alarm is triggered.
Allows setting a frame rate output limit for the H.264 video
stream. Default value is “Max” minimum fps is 1. Reducing the
frame rate output is another way to control the bandwidth used
for the H.264 video streaming from the camera trade off is the
obvious reduction of frame rate output at the camera. Options
are 0 to 30. No default.
Provides the ability to set the resolution. Options are Full or
Half. Half is the default.
Shows the beginning time frame of the video being recorded.
No default.
Shows the ending time frame of the video being recorded. No
default.
Allows the user to delete any previously recorded video on the
SD card.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
To Next Page
Loading...
Need help?
General
