Installing TCP/IP in Windows® 95/98
3-2
NetDSL Software User’s Guide
A. If you see TCP/IP listed under Network Components, you already
have TCP/IP on your Windows
®
95/98. Proceed to configuration
directions for Windows
®
95/98 in Section 3.4.
B. If you do not see TCP/IP listed under Network Components, you do
not have TCP/IP on your Windows
®
95/98. Proceed to the next
section, “Installing TCP/IP in Windows
®
95/98.”
3.3 Installing TCP/IP in
Windows
®
95/98
Step 1. From the Configuration tab in the Network window, click Add.
Step 2. Select Protocol for the type of network component, and click Add.
Step 3. Choose Microsoft for Manufacturers list box and TCP/IP for Network
Protocols list box, then click OK.
Step 4. Check to see TCP/IP is listed under Network Components.
A. If you do not see TCP/IP listed under Network Components, you
have not installed TCP/IP. Repeat Steps 1 - 4.
B. If you see TCP/IP listed under Network Components, you already
have TCP/IP on your Windows
®
95/98. Proceed to configuration
directions for Windows
®
95/98 in Section 3.4.
3.4 Configuring TCP/IP
in Windows
®
95/98
Step 1. From the Configuration tab, select TCP/IP (for Ethernet adapters) listed
under Network Components and then click Properties.
Step 2. Select the IP Address tab.
You now have the option of using either dynamic or static IP addressing.
To enable dynamic IP addressing
Step 1. Click Obtain an IP Address automatically.
Step 2. OPTIONAL* Click the DNS Configuration tab and select Disable
DNS. If you previously entered any parameters, clear all pre-existing
settings.
Step 3. Select the Gateway tab and then click Remove to clear all pre-existing
settings.
Step 4. Click OK to exit TCP/IP Properties window and click OK to exit
Network window. When prompted, restart Windows
®
95/98. If you are
not prompted to restart Windows
®
95/98, do so manually. Proceed to
Chapter 4, “NetDSL Manager.”
* If specifically required by your ISP, you may need to enter DNS
information.
To Next Page
Loading...