To Next Page

To Previous Page

CH5 操作 Operation Original

變更速度範圍

Change range

(1) 從直接變至列齒輪驅動

From direct to back gear drive

u 移動桿 B 至右方

Move lever B to the right.

u 移動控制鈕 C 指向 IN 方置

Move knob C to IN position.

註: 此時主軸轉向相反。轉動馬達開關於相反位置，以得到與變速前相同的轉向。

NOTE: This action will REVERSE the spindle rotation. Move motor switch to reverse

position to obtain original direction of spindle rotation.

(2) 從後列齒輪變至直接驅動:

From back gear to direct drive:

u 移動桿 B 至前方位置

Move lever B to the front position

u 用手轉動主軸直至感覺離合器嚙合為止

Rotate spindle by hand until the clutches are felt to engage.

u 移動控制鈕 C 指向 OUT 位置

Move knob C to OUT position.

註: 此時主軸轉向相反。轉動馬達開關於相反位置，以得至與變速前相同的轉向。

NOTE: This action will REVERSE the spindle rotation. Move motor switch to reverse

position to obtain original direction of spindle rotation.

Argo 2S User Manual

Questions and Answers: