Warning
Do not wet the appliance or immerse it in water, otherwise electric shocks may occur.
Use a damp and soft cloth to clean the exterior surface of the dehumidifier.
Do not use solvents, petrol, xylene, talcum powder or brushes to clean the unit: these may damage
the surface or colour of the casing.
We advise removing the tank once every few weeks to prevent mould and bacteria forming on it. Fill the tank with clean
water a small amount of detergent; swill the water around in it, then it out and rinse it thoroughly.
The filter is designed to remove dust or dirt from the air.
If the filter is clogged by dust, electricity consumption will be higher than normal.
For most effective dehumidification, clean the filter every 250 hours of
operation. After 250 hours of operation, the FILTER RESET (Dry Digit 13 and 17)
led turns on to indicate that it is time to clean the filter.
Cleaning instructions:
1. Compress the two tabs and pull the filter out.
2. Clean the filter with a vacuum cleaner or wash it with clean water at no more
than 40°C.
DO NOT USE ALCOHOL, BENZENE OR OTHER AGGRESSIVE PRODUCTS TO
CLEAN THE FILTER.
3. Leave the filter to dry naturally, then reposition it in the relevant slot.
4. Press the FILTER button (Dry Digit 13 and 17 only).
To Next Page
Loading...
Need help?
General
