2
EG
Contents
Generalities 2
Introduction 5
Rating data 8
How to install Emix 8
Electrical connections 10
Control panel 11
How to use Emix 11
How to use and set the electrical heater elements 12
How to disconnect and/or remove Emix unit 13
How to connect Emix to a solar thermal system 13
DECLARATION OF CONFORMITY
This product is marked as it satisfies Directives:
– Low voltage no. 2006/95/CE.
– Electromagnetic Compatibility no. 89/336 EEC, 92/31 EEC and 93/68 EEC.
This declaration will become void in case of misusage and/or from non observance though partial of Manufacturer’s
installation and/or operating instructions.
INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN
DIRECTIVE 2002/96/EC
At the end of its working life this equipment must not be disposed of as an household waste.
It must be taken to special local community waste collection centres or to a dealer providing this service.
Disposing of an electrical and electronic equipment and its batteries separately avoids possible negative effects on the
environment and human health deriving from an inappropriate disposal and enables its components to be recovered
and recycled to obtain significant savings in energy and resources.
In order to underline the duty to dispose of this equipment and batteries separately, the product is marked with a
crossed-out dustbin.
F-GAS Regulation (EC) No. 842/2006
Do not vent R410A into atmosphere: R410A is a fluorinated greenhouse gas, covered by Kyoto Protocol, with a
Global Warming Potential (GWP) = 1975.
Generalities
Recommendations
• The personnel responsible for receiving the unit must conduct a visual inspection in order to identify all damage to
which the unit may have been subjected during transport: refrigerating circuit, electrical cabinet, chassis and cabinet.
• During installation, troubleshooting and maintenance operations, never use the pipes as a step: under the stress, the
pipes may break and the refrigerant may cause serious burns.
To Next Page
Loading...
Need help?
General
