Argo EMIX User Manual

6
EG
Emix always works in heating mode even if the other units are working in cooling mode; when these work in this mode,
Emix is able to recover the heat which would otherwise be lost in the outdoor air, signi cantly increasing the energy
ef ciency of the entire system.
There are several possible con gurations with Emix and the one represented in the previous  gure is just one of many.
Emix and Emix tank must be connected to an outdoor unit of the iSeries range equipped with special software and a
speci c connection dedicated to Emix. The compatible outdoor units are all the following outdoor units of the iSeries
range with EMX port (*)
(*) All the previous models does not support Emix that is normally connected to EMX port, excluding AEI1G30EMX/
GR9FI30R5IBA that have only one port for single split con guration made to produce DHW by inverter outdoor unit.
The following diagram illustrates the concept exposed on the previous page and shows a system con guration where
three indoor direct expansion units, a hydrokit for a  oor system and an Emix tank coexist, all connected to a G110EMX.
ARGO OUTDOOR UNITS TECHNIBEL OUTDOOR UNITS
AEI1G30EMX GR9FI30R5IBA
AEI1G42EMX GR9FI42R5IBA
AEI1G50EMX GR9FI50R5IBA
AEI1G65EMX GR9FI65R5IBA
AEI1G80EMX GR9FI80R5IBA
AEI1G110EMX GR9FI110R5IBA
H
2
O
AW AW
AF
HK
4
3
2
1

Argo EMIX Specifications

General

Brand	Argo
Model	EMIX
Category	Boiler
Language	English