Argo THOR PLUS - CARE AND MAINTENANCE; Cleaning the air filter; Cleaning of casing; Storage

37V 12/23
WARNING!
Before carrying out any cleaning or maintenance operations, unplug the appliance.
1. Cleaning the air lter
The air lter must be checked at least once every two weeks of operation.
Operation with a dirty or clogged lter always causes a reduction in the
efciency of the air conditioner and can cause serious problems. To remove
the lter, unhook the rear grille (Fig.1) and then remove the lter, gently
pulling it upwards (Fig.2). Use a vacuum cleaner to remove dust. If this is
not enough, wash the lter with warm water and possibly neutral detergent,
rinse it with cold water and let it dry naturally before putting it back in its
place. Once the lter has been reinserted, close the grille and resume use
of the air conditioner.
The lower air lter is screwed on and therefore cannot be removed
2. Cleaning of casing
Use a damp and soft cloth to clean the outer surface of the appliance. Do not use excessively hot water, solvents,
petrol or other aggressive chemical compounds, talcum powder or brushes: these may damage the surface or
colour of the casing. Remove any stains using lukewarm water with a little neutral detergent. Do not pour water
onto the air conditioner to clean it, as this may damage its internal components or cause a short-circuit.
3. Storage
When the air conditioner is not expected to be used for a long time, clean the lters before storing it away. Keep
the appliance in a vertical position at all times. Do not place heavy objects on top of the air conditioner. It is
advisable to protect the appliance with a plastic sheet.
4. Transport
Transport the air conditioner in the vertical position. Should this not be
possible, rest it on its right-hand side; when the appliance reaches its nal
destination, place it immediately in the vertical position and wait at least 4
hours before operating it in cooling mode.
5. For complete safety, regularly check the condition of the power cord; should it be damaged as a result of wear,
contact the Service Centre to replace it.
CARE AND MAINTENANCE