1. OPOS RS232 Setting Instruction.
Please refer to the following steps to setting the driver and scanner.
AS-8120/8150/8250/8310/8312/8510/8520/8000CL/8020CL
Step 1. Launch ArgoxOpos_Driver.exe, OPOS driver will be installed under C:\Program
Files\Argox\ArgoxOpos
Step2. Reset your scanner by “!IN” command.
Step2-1: Enter Program Mode
Step2-2: Reset Default Setting
Step3-1: Enter Program Mode
Step3-2: Opos Setting
Step3-3: Finish
2.
Data Event Demo
.
Prerequisite: .Net FrameWork 2.0 is required to installed on the system.
Step1. Launch ArgoxOpos_Demo.exe to install Demo program.
By default, demo program “ArgoxApplication.exe” will be installed under C:\Program
Files\Argox\ArgoxOPOS.
A WindowShot is shown as below after execution ArogxApplication.exe.
To Next Page
Need help?
General
