PUMP CONFIGURATIONS
14.203.B_A707 en.SM.V4.3X ARGUS Medical AG 28.03.06 / PJ 8 / 48
8. Press key “START” to
acknowledge to new PIN.
6. Press the “MODE” key.
The flashing decimal
points will change to the
right hand display
CAUTION!
After you switch the pump OFF and ON again you can enter into the configuration
mode only, if you enter the correct PIN code.
e.g.
Please note: The interrogation mode can always be accessed without the PIN.
2.5. Changing an existing PIN code
Enter the configuration mode using present PIN, select add. “0” and set the new
code.
Enter actual PIN code and confirm with “START” key.
Press “MODE” key (#0). The flashing decimal points
will change to the right hand display.
Enter the new PIN code and press the “START/STOP”
key to acknowledge the entered code.
7. Enter now the new PIN Code (max. 4 digit number).
Please remember this code, it will never be visible again!
e.g.
... .
To Next Page
Loading...
Need help?
General