PUMP CONFIGURATIONS
14.164.A_A707en.SM.V1.01.doc ARGUS Medical AG 10.02.04 AS 6 / 38
2.3.3. Step 3
Important remark:
Invalid values entered will be corrected automatically by the pump to the maxima or
minima value allowed for the according address!
7. After entering an address e.g. 10 press the key “MODE”. The
flashing decimal points will change to the right hand display.
1
. . .
.
9. Press key “START” to
acknowledge the value
entered.
The flashing decimal
points change back to
the left hand display.
8. Enter now the value on the right hand
display. The range of the value is given
by the table in chapter 2.6.
10. To quit the configuration mode press the
“ON/OFF” key at least 2 seconds.
Changes in configuration become active, if the
pump is switched on normally again.
To Next Page
Loading...