Argus green stream 707 - Activate Configuration PIN; Change Existing PIN Code

PUMP CONFIGURATIONS
14.164.A_A707en.SM.V1.01.doc ARGUS Medical AG 10.02.04 AS 7 / 38
2. Press key “START”.
3. Press key “MODE”.
5. Enter the default PIN Code “0”. To do
this press the key “10” while keeping the
key “1” pressed. Press “START” key to
acknowled
g
e the entered PIN code.
3.
Pre
4. Press key “START” again. The
display will show “Cod ----“.
2.4. First activation of a configuration PIN Code
The activation of a PIN code allows you to protect the configuration from unauthorized
persons.
To activate the PIN code, enter the configuration mode as described in the previous
chapter. For this use the default PIN code “0”:
After you switch the pump OFF and ON again you can enter the configuration mode only,
if you enter the correct PIN code in display of chapter 2.3.2.
Please note: The interrogation mode can always be accessed without the PIN.
2.5. Changing an existing pin code
Enter the configuration mode (see chapter 2.3), select address 0 and enter the new pin
code.
1. To enter into the configuration mode, switch the pump on
while keeping the keys “MODE” and START/STOP” pressed.
70
7
pro
g
. . .
0
0
8. Press key “START” to
acknowledge to new
PIN.
7. Enter now the new PIN Code (max. 4 digit number).
Please remember this code, it will never be visible
again!
6. Press the “MODE” key.
The flashing decimal
points will change to the
right hand display