Ariens Sno-tek 24 User Manual

GB - 8
PACKAGE CONTENTS
ASSEMBLY
Tools Required:
• Pliers
• Open-end wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or adjustable wrench
• Tire gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Loosen the hardware on the shift rod.
3. Put the speed selector lever in the sixth
forward position.
4. Rotate the handlebars into operating
position.
NOTE: Be careful not to damage cable spring
hooks when rotating handlebars upward.
5. Install and tighten the hardware on the
handlebar assembly and shift rod.
.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Dropping or tipping over
boxed unit could result in personal
injury or damage to unit.
Figure 3
1. Sno-Tek™ Unit
2. Discharge
Chute
3. Chute Crank
4. Literature Pack
with Extra
Shear Bolts
1
2
4
3
OS8261
Figure 4
OS8025
1
2
3
1. Shift Rod
2. Upper and Lower Handlebar
Hardware
3. Shift Rod Hardware
4. Handlebar
4

Ariens Sno-tek 24 Specifications

General

Clearing Width	24 inches
Engine Displacement	208 cc
Stage Type	Two-stage
Fuel Type	Gasoline
Intake Height	20 inches
Number of Speeds	6 forward, 2 reverse
Chute Material	Polymer
Impeller Diameter	12 inches
Transmission	Disc-O-Matic
Fuel Tank Capacity	2.9 quarts
Chute Control	Manual
Skid Shoes	Adjustable
Start Type	Recoil
Tire Size	13 x 4 inches
Throw Distance	40 feet