20 ExTensor
6.1.3 Menu system overview
Menu items
Depending on the selected user, stored access authorisation, set parameters and the model type of the actuator, single menu items
may be invisible/hidden differing from the following overview.
x = menu item visible
Menu Sub item Function
Standard
POTI (Potentiometer)
A-OUT (Analog output,
Current/Voltage output
CONTROL (Controller, i-Act)
MAIN MENU Main Menu
XLOGIN Login (Select user)
End positions Set up end positions (Left & right)
Poti input Settings for operating the actuator
via external potentiometer
X
Poti output Settings for potentiometer output values
(Feedback)
X X
Set value Settings for set value defaults
(Drive via set value)
X
Actual value Settings for actual value output
(Feedback current/voltage)
X X
Relay switch Programming relays behaviour
(Option board)
visible only with attached relays module
(Option board)
EXPT. MENU Expert Menu
XSignal IN Selection of input signal for driving the actuator
Signal OUT Selection of output signal for position feedback
Wire monitor Setting of actuator behaviour in case of cable breakage
(formerly wire break monitoring)
X
Status info Activate/Deactivate message output X X X
Offset Settings for allowed control deviation in controller mode X
To Next Page
Loading...
